The Arduino MKR WiFi 1010 is the easiest point of entry to basic IoT and pico-network application design. Whether you are looking at building a sensor network connected to your office or home router, or if you want to create a BLE device sending data to a cellphone, the MKR WiFi 1010 is your one-stop-solution for many of the basic IoT application scenarios.
The MKR WIFI 1010 is a significant improvement on the MKR 1000 WIFI. Its equipped with an ESP32 module made by U-BLOX. This board aims to speed up and simplify the prototyping of WiFi-based IoT applications thanks to the flexibility of the ESP32 module and its low power consumption.
Pinout diagram:
This thin board has been designed to offer a practical and cost-effective solution for makers to design IoT projects with minimal previous experience in networking. It is based on the low power Arm Cortex-M0 32-bit SAMD21, which is part of the Arduino MKR family. Wireless devices specifically designed for the Internet of Things (IoT).
Features:
- Digital I/O Pins: 8
- PWM Pins: 12
- Flash Memory: 256 KB
- SRAM: 32 KB
- Microcontroller: SAMD21 Cortex-M0+ 32-bit low-power ARM MCU
- Board Power Supply (USB/VIN): 5V
- Full-speed USB device and embedded host
- Pre-mounted headers with pin-out
Additional information
Microcontroller SAMD21 Cortex-M0+ 32bit low power ARM MCU (datasheet) Radio module u-blox NINA-W102 (datasheet) Board Power Supply 5V (USB/VIN) Secure Element ATECC508 (datasheet) Supported Battery Li-Po Single Cell, 3.7V, 1024mAh Minimum Circuit Operating Voltage 3.3V Digital I/O Pins 8 PWM Pins 13 (0 .. 8, 10, 12, 18 / A3, 19 / A4) Interface 1 x UART
1 x SPI
1 x I2CAnalog Input Pins 7 (ADC 8/10/12 bit) Analog Output Pins 1 (DAC 10 bit) External Interrupts 8 (0, 1, 4, 5, 6, 7, 8, 16 / A1, 17 / A2) DC Current per I/O Pin 7 mA Memory CPU Flash Memory 256 KB (internal)
SRAM 32 KB
EEPROM noClock Speed 32.768 kHz (RTC), 48 MHz LED_BUILTIN 6 Length (mm) 61.5 mm Width (mm) 25 mm Weight (gm) 32
Reviews
There are no reviews yet.